How to make a fake ID that scans 9 Steps

The following information is a manual on how to make a fake id that scans in just 9 easy steps. To make this ID, you will require the following materials:

Synthetic paper;
Butterfly laminate pouches;
A pouch laminator;
An encoder to encode the magnetic strip attached on the pouch.

How to make a fake ID that scans in 9 Steps

Search and download an ID template; then change the required text fields to customize your ID the way you need. Most IDs have a standard Arial font that is available with any word processing software. Don’t forget to edit hair and eye color fields to complete your editing. The color abbreviations for both can be easily found on the web.

Scan your photo and signature. Next, you need to clear the background of your photo to fit smoothly into the fake ID’s template. There are many programs that should help you to do the editing easy and stress-free. The obvious choice is Adobe Photoshop, but there are a number of free alternatives as well. See the manuals of the corresponding software you choose to understand how to edit background.

Supplement your fake ID with a barcode. The most common barcode used in the driver’s license is PDF417 barcode. It contains most of the data stored on the front of the license. To encode the data you need into this barcode, edit its readout. To do that you need to find some free version of barcode-generating software.

Next step will tell you how to make a fake ID that scans as opposed to the one that doesn’t. The difference is a magnetic strip. To make your ID scan-able you have to attach the stripe and further to encode it. You will require an encoder, mentioned in step one of this manual. These encoders are very expensive, but if you want a scan-able ID, you can’t get away without acquiring one. They are all expensive, but you can still distinguish between low cost and high-end encoders. If you want to make sure your magnetic strip will be nearly impossible to demagnetize, opt for a high-end encoder. The easiest way to encode the stripe is to decode a working driver’s license, edit the information you need and then encode all the changes back onto the stripe.

Now that you know how to make a fake ID that scans, it’s time to get familiar with the printing arrangements. You require synthetic paper; the most famous brands of synthetic paper are Teslin and Artisyn. If you use an inkjet printer, choose Artisyn, as with Teslin you can achieve some weak results. If you use a laser printer, you may get away with both of these options. Note that Artisyn is a cheaper alternative. Always print using best quality settings to make sure you get the best results.

Use a paper cutter to cut an ID paper and a butterfly pouch to ensure you don’t mix up with the ID dimensions.

Place the card into a carrier and laminate using thermal pouch laminator. Otherwise, a butterfly pouch and synthetic paper won’t stick together. There is an option to do the same job with a simple iron, but it’s a lot more risky, and normally the results will not be perfect. After you’re done, place your card under a book or something similar to make sure it’s flat once it cools off.

In the last step you need to attach a hologram. Holograms are rarely checked, so more often than not it’s OK to use a generic hologram. The Shield and Key hologram is of the generic holograms that resembles a transparent rainbow hologram. If you still need an authentic one, there are ways to replicate a hologram. You can even make a hologram yourself – there are various manuals on the web to help you do that.

Finally, to make your ID look complete use very fine grit sandpaper to sand the edges of the hologram. It is also recommended to slightly sand the ID on both sides to make it look like it’s been in use for some time.


How to make a fake ID that scans

That’s it for the steps, so now you know how to make a fake ID that scans and is extremely close to an authentic one.


You can read more fake id market analytics here.